Is it acceptable to have two or three different subnets running on a LAN? Of course, only one of them can have a DHCP server. The other LANS would have to have static IP settings.

Curios about the WiFi 6 Performance of the new Unifi 6 Access Points? Read my full review of the new Unifi 6 Lite and 6 Long Range in this article, including performance tests. Have you installed the Unifi Controller? There is no need to turn off the access point when adding an extra AC. You can simply adopt it in the controller.

Ubiquiti UniFi AP AC Pro Indoor / Outdoor Access Point (UAP-AC-PRO)

I have been looking to replace it with something newer but it doesn’t seem like there is a good small replacement for the USG-3P. I hope this post helped you to reset Unifi AP to its factory defaults and then you can adapt it again in your controller.

I may completely reset all devices to their factory settings and start all over again, but I am not sure if that wil resolve anything? At the moment of writing is this really the goto access point from Ubiquiti for outdoor installation. The advantage of the UniFi Mesh models is that they have antennas that are designed for long-range mesh performance. Making them great to cover large outdoor areas. Keep in mind that wired is always better, but that is outdoors not always an option. how the U6 Pro 2.4 GHz perf can be so good (573.5 Mbps) whereas U6 lite is also using 2×2 MIMO and only reaches 300Mbps ?We have an existing SonicWall router that we need to continue using. Is this a setting issue with the way I setup the access points using the controller, or is it an issue with our router settings? Well to controller the access point you will need the Unifi Controller. You can run them through a netgear switch, that won’t be a problem, as long as they can get power (with the PoE adapter or with the netgear switch) Regional regulations must be observed when deploying radio equipment. More info Power Input Power Consumption Does the access point project my network if I don’t do anything other than plug it in to my lan (through the POE)? In other words, can I use it to function essentially as an extender without any configuration?