Slim's introduces the incredibly easy to use, effective, and revolutionary TRUE WIPE-LESS spray sealant! CARPRO HydrO2 is formulated with Hydrophilic glass fibers, silicon polymers, and fluoropolymers and can be applied to all vehicle surfaces! Paint, glass, plastic, convertible tops, wheels, calipers, and wheel wells are all easily within reach with HydrO2. HydrO2 was specifically formulated to save time and therefore money for all the Car pros and enthusiast alike! Finish by "flood rinsing" the vehicle without a spray nozzle to push all the water off from top down. Do NOT apply HydrO2 in the sun or to a hot surface! Applying in this manner may cause streaks that do not wipe off easily. One of our greatest innovations of all time (Hydro2) is now even easier to use and available in the new ready to use version known as HydrO2 Lite! HydrO2 has an extremely good cost/performance ratio. With only 40ml of product required to complete an average size sedan, including all paint, glass, trim and wheels.

Protect everything: Apply to areas you never could before! Not only body panels but protects calipers, undercarriage, wheel wells, door jambs, in between seals and more. Excellent gliding lubrication and a wonderful fresh scent make for a safe, and enjoyable wash experience. CarPro Hydro foam is a snow foam that not only cleans but seals the paint with a silica rich formula designed to last months in one easy to use solution. HydrO2 is meant to be applied and then immediately rinsed away using a strong stream of water. In ideal conditions, the product should be rinsed from the surface no more than 1 minute after you have started applying the solution to the panel you are working on. Ideal conditions consist of low humidity, moderate temperatures, and a cool surface. Since many of us will be using this product in warmer environments with potentially high humidity, it is important to remember to rinse the solution from the surface right away. I recommend working on only one panel at a time, beginning with the horizontal panels (roof, then hood, then trunk) and then working your way around the vertical panels. Mist a small amount of product onto the panel, and immediately rinse away (usually within 30 seconds from the time you started applying). There is no reason to let the product dwell on the surface. Also, remember to thoroughly soak the panel before application. Incorrect Dilution of Product with Water

Spray, rinse, coated, it's that easy.

Paint, glass, plastic, wheels, calipers, and wheel wells are all easily within reach with HydroFoam. This amazing rich foam wash and sealant in one thats lifts and removes dirt, whilst leaving a ultra-water-repellent! This results in a durable silica shell that produces a brilliant protected shine that is incredibly easy to maintain.

Do not apply HydrO2 in the sun or to a hot surface! Applying in direct sunlight will lead to streaks that do not wipe off easily. Finish by "flood rinsing" the vehicle without a spray nozzle to push all the water off from the top down. Update (5/23/17): CarPro now recommends diluting 1 part Hydro to 6~10 parts water. This new dilution ratio really helps reduce the risk of streaking/staining and may be a big help to some users who are struggling to enjoy the product. Not Accounting for Over Spray Can be used safely on any surface. Dirt and water are repelled from the surface. No cure time needed. Resistant to nearly all acids, alkaline solutions, and solvents. Instantly enhances the gloss, depth, and smoothness of your paint. CARPRO HydrO2 Touchess Silica Sealant is a concentrated solution. You dilute 1 part concentrate with 6 parts water – we recommend using a SprayMaster Heavy Duty Spray Bottle.Since HydrO2 is applied via spray bottle, it is not possible to be too precise with your application. Consider the scenario of applying HydrO2 to your roof. As you are spraying, there are particles of solution in the air that may miss the roof, and settle on the glass surrounding the roof, or even drift further and land on the hood, a door, or the trunk. Also, if you are applying the solution to your hood, it is highly likely some over spray will land on the fenders, bumper, and glass. You must be aware of any possible over spray areas while you are working, especially if you are working outdoors, and even more so if it is windy. It is a good idea to not only rinse the panel you are working on, but also those that are nearby, to reduce the chances of that over spray causing streaks if it is allowed to dry before you work on that panel. CarPro Reset is especially known for its ability to rejuvenate and deeply cleanse silica-based coatings such as CarPro CQuartz SiC, CQuartz UK Edition, Reload, Hydro and any other silica-based paint coating. It also helps the coatings release contamination from the coated surface. Pre-mixed with a higher concentration, Carpro HydrO2 Liteoffers more shine, protection and importantly value for money than any comparative product on the market. Spray fine mist of diluted HydrO2 on no more than 1/4 of vehicle before rinsing. Very little is needed and no overlap is needed.

Spray fine mist of HydrO2 on no more than 1/4 of vehicle before rinsing. Very little is needed and no overlap is needed. HydrO2 is sold in a concentrated form. The product needs to be diluted with distilled water to create the solution that will be used to spray on your vehicle. The dilution ratio for HydrO2 is 4 parts of distilled water to 1 part of HydrO2 Concentrate. This is very important, as a weaker dilution may yield decreased durability and gloss, while a higher dilution may make the product more difficult to use. It is recommended that you only mix enough solution to use within a short period of time, so do not mix the entire bottle of concentrate if you do not intend on using it right away. Simply mix a small amount before each job, and store the remaining concentrate indoors to help prolong the shelf life. Dilute 1 part HydrO2 to 6-10 parts water. A spray bottle is suggested for fast and easy application.

CarPro - HydrO² Lite Wipeless Spray Sealant

Spray on and rinse off – that’s how simple CARPRO HydrO2 Touchless Silica Sealant is to apply. Read that sentence again – notice anything? There is no rubbing or buffing when you apply CARPRO HydrO2 Touchless Silica Sealant. Simply wash your car like you normally would and while it’s still wet, spray HydrO2 over every surface including paint, wheels, chrome, convertible tops, and glass, and simply rinse it off. After you’ve thoroughly rinsed HydrO2 off the surface, dry the vehicle with a quality microfiber drying towel or car dryer, like the Metro Master Blaster, and your vehicle will be protected for up to 3 months. HydrO2 instils a protective layer onto the surface that repels contaminants and creates an extreme hydrophobic effect on the surface. It improves the gloss of the vehicle immensely and creates maintenance to be effortless. Introducing the incredibly easy to use, effective, and revolutionary TRUE WIPE-LESS spray sealant! CarPro HydrO2 is formulated with Hydrophilic glass fibers, silicon polymers, and fluoropolymers and can be applied to all vehicle surfaces! Paint, glass, plastic, convertible tops, wheels, calipers, and wheel wells are all easily within reach with HydrO2 Lite. HydrO2 Lite was specifically formulated for the DIY guys looking to get the insane gloss and incredible self cleaning effect offered by Hydro2! This amazing ready to use coat forms an ultra-water-repellent coating and is applied by simply spraying and then rinsing off with only water! Hydro Foam was formulated with hydrophilic glass fibers, fluoropolymers and can be applied to all vehicle surfaces! Paint, glass, plastic, wheels, calipers, and wheel wells are all easily within reach with HydroFoam. This truly unique foam wash and sealant (in one) lifts the dirt whilst in the Merino wiping stage and then, during the rinse phase, an ultra-water-repellent coating is immediately formed!