Example of how to connect two gutters - Standard quick code '56' + quick codes ('878' x 1) + ('884' x 2) + ('879' x 1) + ('881' x 1) + ('2634' x 1?

The 40mm says 40mm on the packet and inside are fittings that say 40mm and 40mm pipes fit into them. Attach the waste pipe to the floor, ceiling or wall using a pipe clip or fit them around bends and corners with a pipe bend at 90°, 92. Finaly cut a 32mm pipe to size that could meet the 36mm pipe inside the 40mm pipe leaving enough length to fit a 32mm pipe extension joint.But I have just bought a macerator which specifies solvent weld (understandably) - in my naivety I bought a stack of solvent weld 32 and 40mm fittings from the UK. Refer to the size chart or check the pipe for markings to identify the type (look for ABS, indicating a solvent pipe).

Now get busy with a tube of sealant rubbing plenty along the pipes to be inserted into the 40mm pipe then push them in untill they meet roughly at the centre of the 40mm tube.

If the item comes direct from a manufacturer, it may be delivered in non-retail packaging, such as a plain or unprinted box or plastic bag.

All Brett Martin products including Brett Martin 32mm Waste Pipe P/P Black Black 3000 x 36 x 36mm are manufactured under a quality management system certified to BS EN ISO 9001:2015 offering you peace of mind that these products will satisfy current industry and legislative requirements. If your existing is defo Push Fit then the fitting you found in Wickes should do the job, as already mentioned, a mechanical or compression coupler will cover you for Pf or SW. This 90 degree bend is usful if you wish to take the water straight down or two join two pipes for example. Bear in mind (although some disagree) that whilst all solvent weld waste is a standard size across all the manufacturers, push fit isn't.Your existing pipes might be solvent weld, which is not compatible with push fit at all, as the pipe is larger and made from ABS rather than polypropylene. However, this excludes damages caused by accidents, neglect or misuse of the Solvent Weld Waste 90 Degree Tee.