The pictogram of the bullet trajectory was ‘curved’, I assume to show that if you lead the target the bullet impact will coincide with the target’s location. Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). By rejecting non-essential cookies, Reddit may still use certain cookies to ensure the proper functionality of our platform. They are very sharp, not fully multi-coated so the contrast is not as high and there is some ghosting with light coming in at an angle.

Tony, the post that you mention is the reason I’m asking here, to get maybe an independent confirmation to this info. I have a LOT more 10mm brass than I'd use in two lifetimes so I bought and fit a 9x25 Dillon barrel (Wilson feed ramp) for my long slide 10mm.They asked for my address and without cost to me sent me a few extras and some bonus parts for the resizing die. These primers are pretty flat and I had one piece of brass come apart on me (after it came out of the pistol, it was cracked and broke in two, but they say don't use used brass). I wrote Dillon to see if their 750 station locations are fluid enough to accommodate this exact sequence, if it will I'm in if only to save that fifth offline crimp operation. Is there any reliable information on “special”, more powerful loads used by Hungarian or Austrian armed forces in 9x25?

With the Sig case, to meet LOA I wouldn't think lube rings would be exposed unless you are using a free bored barrel in a full sized 1911 type pistol (not a short framed . Small enough to take anywhere, they're ideal for getting great views for that next holiday, concert, or sporting event. You could probably shoot the CFE load all day long, the longshot is like trying to run drills with full house 10mm.EDIT: Annealing will reduce the likelyhood of splits, and helps with reforming the brass from 10mm to 9x25.

Competitors in the late 1980s and early 1990s who were using the 9×25mm Dillon used the additional powder available over . These would obviously be very high pressure loadings, possibly unsuited to a conventional blowback SMG (the Kiraly mechanism used a retarded blowback).

After some thought I partially retracted this statement because it would be so simple to use a steel core in place of the iron core in an mE bullet, that I can’t believe that nobody tried it out to see what it would do.