About this deal
Once cut, add the screw cap, seal and washer to the base of the pipe and push it into the compression waste and then push the washer and seal down and screw the screw cap up tightly.
In this case you can simply drill a hole through the wall and run the appliance waste through it out to the drain or connect to the soil pipe using a strap on boss.
What is a Waste Trap?
Quite often there is some nasty sludge in there also and you don’t want that getting everywhere either.
Finally add pipe clips at least every 600mm. Screw to the wall securely using wall plugs. Remember to retain the correct fall for waste pipes so any water flows as it should, minimum of 1:40. Ensure this slopes towards the waste outlet. In some cases like this it may be possible to extend the waste pipe hose on the appliance to reach a little further but this should only be done if the manufacturer allows it and you use the correct extension kit stated by the manufacturers and that it doesn’t exceed a total length once extended of more than 1.5 metres.In terms of the waste trap itself the document states that it should be at minimum 40mm in diameter and the depth water in the trap to form an effective seal should be at least 75mm. Once the waste hose is connected you can tighten up the jubilee clip to make the hose really secure. Jubilee Clip On Washing Machine Waste Pipe