height adjustable, super-wide & curved aluminium T-bar with dual-coloured TPR ergonomic grips and an anti-scratch sleeve inside the anodized coloured column (33mm diameter). Standing on the scooter, one hand on each handle, push with one of your feet to move forward. Proceed with caution at the start. Shoes are mandatory and we strongly advise you to wear trousers and long sleeve shirts to avoid injury if you fall. Battery chargers used with the scooter are to be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the damage has been repaired.

Modifications: the original product must by no means be modified except for the maintenance-related changes mentioned in these instructions. Use with caution on a flat, clean, dry surface and, if possible, away from other users, and obey the road safety rules. When the signal light is red, the battery is charging; when it switches to green, charging is completed. This takes approximately 2 hours. Warning! Be careful when you do any installation and transformation work. While turning the T-bar, make sure no other people are in the close vicinity around the scooter since the T-bar turns requires a big turning angle. Keep the kids in a safe distance while installing & transforming the scooter to avoid accidental injuries.The Globber Ultimum series is the biggest, widest and most robust scooter in the market and will revolutionise three-wheeled scooters for children aged 5 and over. Globber scooters was also recognised by the Hong Kong Government Consumer Council (GovHK) as the safest scooter out of 15 branded scooters and passed all performance tests**.

After selecting «Auto» or «On» mode, press the round rubber button to activate your selected mode; press the button again to change the light pattern. ULTIMUM is provided with an adjustable T-bar which can be adapted to the user’s height (6 positions). The spring loaded button shall be in the hole when adjusting the T-bar height.

A brake is located at the rear, when necessary, press down on it to slow down. Press down gradually to prevent skidding or loss of stability. The metal brake may heat up after multiple uses. Avoid touching it during and after use. Auto» mode: the base of the scooter will flash only when the scooter goes over uneven paths. This is operated by a vibration sensor in-built in the module; there will be no light when it is not in motion for energy saving. Two high-quality & high-rebound 125mm (43mm wide) front PU casted wheels, and one 90mm (48mm wide) rear PU casted wheel, mounted on ABEC 7 bearings.