Reolink PoE Security Camera 5MP Super HD with Human/Vehicle Detection, Support Audio Dome Outdoor Indoor Home CCTV Camera IP66 Waterproof IP Camera RLC-520A 2Pack

Product Information

After plugging the new camera to the NVR, the camera's image does not show up on the monitor and it prompts "video loss". The following troubleshooting may be helpful to you. Or if you want to make Reolink NVR work with the camera, its connection diagram will be like below:

For redundancy, these sensors are polled every 60 seconds together with the update of all other entities.PTZ left, right, up, down, zoom in and zoom out will continually move the camera in the respective position until the PTZ stop is called or the hardware limit is reached. Then power up the camera while pointing it at the QR code. It takes about a minute to initialize, read the QR code, and connect to your Wi-Fi. Showing the camera in the dashboard Follow the on-screen instructions to first setup the credentials (use the same credentials in Home Assistant). However I discovered that the sound and audio were gradually drifting out of sync - up to about 4 seconds apart. The video is lagging behind the audio. This means that not only is the recording out of sync but also the snapshot starts to miss the event due to the video lagging. If I disable and re-enable the camera in SSS it is all great again but then the drift starts again.

This integration creates a few camera entities, one for each stream type with different resolutions: Main, Sub, Ext, Snapshots Main, and Snapshots Sub.The camera may work in extremely cold conditions as low as -25°C as it will produce heat when powered on. You may power on the camera indoors for a few minutes before installing it outdoors.

iSpyConnect has no affiliation, connection, or association with Reolink’s products. The connection details provided here are crowd sourced from the community and may be incomplete, inaccurate or out of date. We provide no guarantee or warranty that you will be able to connect to your cameras using these URLs. In some camera models, there is a delay of up to 5 seconds between the turn-off command and the sound stopping. The siren turn-on service supports setting a volume and a duration (no turn-off service call is needed in that case). Switch entities If you just received your new camera and are not familiar with the camera, you can have a look at the below video about the unboxing, setup, and installation of the camera. Do not point the camera toward a glass window. Or, it may result in poor image performance due to the window glare from infrared LEDs, ambient lights or status lights. This issue is related to the function of the camera itself, and it is indeed a temporary workaround solution so that your camera can maintain the synchronization of audio and video.Please install the waterproof lid at the junction of the Ethernet cable and the camera to protect the junction from water. An SSL certificate can still be enforced for external connections, by, for instance, using the NGINX add-on or NGINX Proxy Manager add-on instead of a globally enforced SSL certificate. When using the siren turn-on service, the siren will continue to sound until the siren turn-off service is called.